![]() ![]() ![]() Anyway, I can see there have been a few issues with getting the cutter to actually cut, and am wondering if anyone can throw any light on the following issue please. I've just bought this from e-bay - yes I know - not a good move. Training sessions take approximately 1 to 2 hours and can cover SignCut, Flexi, InkScape (text on path, offsets, vectorization), contour cutting and your cutter functionality.I found this thread through lots of trawling on the internet, as I too have a problem with the liyu cutter - model SC1361. With your software installed, and your cutter setup on its stand and connected to your computer, we highly recommend you call us at 88 to schedule your training session. SignCut will display an X on the screen.ġ2) Select the cut icon on the left side of the screenġ3) The cut / plot pop up window will displayġ4) Select to “Cut out” in the bottom left corner to send a test cut to your cutter.ġ5) Your cutter should move around as if it were cutting the X.ġ6) Your cutter is now communicating with SignCut and is ready! This can be done by unscrewing the thumb screw and pulling the blade holder up and out of the carriage.ġ1) In SignCut, select the text button on the left side of the screen. The communication settings will grey out because this is a direct connection.ġ0) Remove your blade holder from the carriage (the blade holder is the metal tube in the carriage that holds the blade).Port – USB00# where # is the USB port number of your cutter.Select the manufacturer, your cutter and the port. This is done by selecting the Cutter button at the top right-center of the screen. Enter this code into SignCut to activate the dongle license.ĩ) Once registered, you will need to select your cutter and communication port. Depending on timing, your activation code will either be with the dongle or it will be emailed to you. If you purchased a dongle, CutterPros will register your license with SignCut.Copy the registration code and save it in notepad or other editor program. This process takes a couple minutes and the codes are issued right away. You will then receive the actual SignCut 1 year license code through your email and listed on the registration screen. This will allow you to register your bundle code. Follow the instructions on this sheet of paper to go to It will say “Document of Value” at the top and contain a bundle code (this is NOT the registration code). It may be in the small box inside the cutter box or included in the documentation packet. If you purchased your cutter with a 1 year license, you will receive a bundle code on a bright yellow or green 8.5×11 sheet of paper included with your cutter.Accept all the defaults to install InkScape when the InkScape pop-up installation window appears.Ħ) If you purchased a permanent license of SignCut and have a dongle key (USB thumb drive), plug it in now.Ĩ) SignCut will ask you for your registration code. ![]() We recommend you go to to download and install the latest stable version directly from the InkScape web site. TIP: SignCut may not install the latest copy of InkScape.InkScape is a free graphics program capable of bitmap vectorization somewhat similar to Corel Draw and Adobe Illustrator. This can be done by selecting save to disk.Ĥ) Accept the default directory and installĥ) Select yes to InkScape if you wish to install InkScape. Alternatively you may save this file to your computer and install it after it has been copied to your hard drive.Do this after you have installedĢ) Allow your explorer to run (install) the software TIP: You can download the plugins for InkScape,Ĭorel Draw and Illustrator here as well.Open the “+” to see the files and select Windows.1) Download the latest version of SignCut from: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |